1. The operating temperature should not exceed 50°C, and the use of open flames is strictly prohibited.
2. When replacing the high-efficiency air filter, you must remove the spray ball plate of the automatic air shower room, take out the high-efficiency filter, and replace the new high-efficiency air filter according to the original high-efficiency filter specifications. When installing, confirm the arrow mark on the high-efficiency filter, and the arrow should point to the direction of the airflow. And to ensure a good seal to prevent leakage.
3. Regularly check and repair the electrical circuit of the equipment. If there is any fault, refer to the electrical schematic diagram for repair.
4. Please wait for more than 2s to open the door after blowing shower.
5. Never open another door with force when one door is open.
6. After the high-efficiency filter is replaced, it is necessary to confirm that there is no leakage in the frame, and use a dust particle counter to detect it, and it can work normally after reaching the technical indicators.
7. When the wind speed is found to be small, first check whether the surface of the primary air filter is black. If it is black, it means that the pre-filter contains more dust and the resistance increases, that is, the primary air filter of the automatic air shower should be removed. The non-woven fabric in the device is cleaned or replaced.
8. Never push the door forcefully in the state of blowing shower.
